PWR-110 · Lesson 6 of 12 · 22 min

Confined spaces, vessels and boiler entry

▶ Video coming soon A video version of this lesson is on the way.

The night before the TSSA inspection in September, boiler 3 had to be opened for the first time since its last annual outage. Tamar was not allowed inside, but she was the attendant's helper, and that turned out to teach her more than going in would have. Pilar Quenneville, the shift engineer in charge of the entry, worked through the entry permit line by line with the two maintenance workers: isolation complete and verified, the boiler drained and cooled, manholes and handholes open, a fan blowing fresh air in through the lower manway and out of the upper one, the atmosphere tested at the top, middle and bottom of the drum, low-voltage lights, and a rescue plan with the harness and tripod set up at the drum manway. When the gas monitor read 20.9 in 100 oxygen and zero for everything else, Pilar signed the permit and the first worker climbed in.

This lesson explains what makes a space confined, why confined spaces kill, and how a boiler, a deaerator or a tank is safely prepared, tested, entered and closed. In Ontario the rules are in O. Reg. 632/05 (Confined Spaces) under the Occupational Health and Safety Act, which applies to all workplaces covered by the Act.

What a confined space is

Ontario's regulation defines a confined space in general terms as a fully or partially enclosed space that is not designed or intended for continuous human occupancy, and in which atmospheric hazards may occur because of its construction, location, contents or the work done in it. Boiler drums and furnaces, deaerators, condensate and feedwater tanks, chemical tanks, flues and breeching, pits and some valve chambers in the steam distribution system can all be confined spaces.

Confined spaces kill in a few familiar ways. The air may lack oxygen, because rusting steel inside a closed vessel has used it up or because an inert gas such as nitrogen was used to protect the vessel. The air may be toxic, from carbon monoxide in a flue, hydrogen sulfide in a sump, or chemical vapours in a tank. It may be flammable. And the space itself may trap people: hot water or steam let in through a leaking valve, a burner fired by mistake, a fan started with someone in the flue. A grim pattern repeats in confined space deaths: the first victim collapses, and one or more would-be rescuers go in after them without breathing protection and collapse too. Many of those who die are rescuers.

A side view of a watertube boiler drum with an upper manway and a lower manway. A fan blows fresh air into the lower manway and air exits the upper one. A tripod and retrieval line stand over the upper manway, an attendant stands outside with a gas monitor, and a worker is inside with a low-voltage light. Labels show isolation of steam, feedwater, blowdown and chemical feed, and the three levels where the atmosphere is tested.
Preparing a boiler drum for entry: isolation, ventilation, testing and rescue equipment.

The rules in Ontario

O. Reg. 632/05 requires an employer whose workers may enter confined spaces to have a written program, and for each space a written hazard assessment by a competent person and a written plan for controlling the hazards. Before each entry there must be an entry permit that records the space, the work, the time, the people, the hazards and controls, the test results, and the rescue arrangements. The regulation requires atmospheric testing before entry and as often as needed during the work, an attendant outside who keeps in contact with the entrants and summons rescue, a rescue plan with trained rescuers and equipment ready, and training for everyone involved.

For the atmosphere, the regulation sets an acceptable oxygen range of 19.5 to 23 in 100 by volume, and flammable gases must be kept below set fractions of their lower explosive limit (LEL). The regulation uses limits of 25, 10 and 5 in 100 of the LEL for different situations; Cantwell's plan, like many, requires below 10 in 100 of the LEL for any entry and below 5 in 100 for hot work. Toxic substances must be below the occupational exposure limits. If the atmosphere cannot be kept safe, entrants need suitable respiratory protection and further precautions.

Atmospheric conditions for entry, in summary (the regulation and the plant's permit govern).
CheckAcceptable for entry (Ontario summary)
Oxygen19.5 to 23 in 100 by volume
Flammable gasBelow 10 in 100 of the lower explosive limit (Cantwell's plan; 5 in 100 for hot work)
Toxic gases (CO, H₂S and others)Below the occupational exposure limits
TemperatureCool enough to work safely (set by the plan)

Preparing a boiler for entry

Preparing a boiler is mostly lockout (lesson 5) on a large scale, followed by cooling, ventilating and testing. The sequence at Cantwell for boiler 3 was:

  • Shut down and cool. The burner was stopped and the boiler cooled slowly over many hours, as the maker's instructions say, to avoid thermal stress. Pressure was allowed to fall naturally, with the drum vent opened once the pressure was low.
  • Isolate everything. Steam stop valves with the free-blow drain open between them, feedwater stop and check valves, continuous and bottom blowdown, chemical feed, sample lines, the gas supply to the burner (locked at the manual shutoff valve, with the burner's own safety shutoff valves also closed) and the burner and fan motors at their breakers.
  • Drain. The boiler was drained to the blowdown tank once the water was cool enough, with the vent open so it would not draw a vacuum.
  • Open and ventilate. Manholes and handholes were opened only after the boiler was confirmed empty and at zero pressure, standing to the side of each cover as it was loosened. A fan blew fresh air in at the lowest opening.
  • Test and permit. The atmosphere was tested at several levels, the permit was completed and signed, the rescue equipment was set up, and the attendant took position.

Inside, workers use low-voltage lighting or lighting protected by a ground fault circuit interrupter, because a boiler drum is a wet, conductive space where a fault at 120 V could kill. Tools are lowered rather than dropped. The attendant keeps a log of who is inside, stays in contact, and never enters to rescue; their job is to raise the alarm and use the retrieval system from outside.

Worked problem

Ventilation air changes

Boiler 3's drum and tube spaces hold about 9.5 m³ of air. The ventilation fan delivers about 0.25 m³/s. How many air changes per hour does that give, and how long does one air change take?

Show solution
  1. Air per hour:
  2. \[0.25 \times 3{,}600 = 900 \text{ m}^3/\text{h}\]
  3. Air changes per hour:
  4. \[900 \div 9.5 \approx 95\]
  5. Time for one change:
  6. \[9.5 \div 0.25 = 38 \text{ s}\]

Answer: About 95 air changes an hour, or one every 38 seconds, if the air sweeps the whole space. In practice air short-circuits between openings, which is why fresh air is blown in at the lowest opening and leaves at the highest, and why testing is done at every level and repeated during the work, not only before entry.

Testing the atmosphere

Gas monitors must be bump tested before each day's use, by exposing them briefly to a test gas to prove each sensor responds, and calibrated as the maker's schedule requires. Testing starts from outside, lowering the sampling hose into the space to test at the top, middle and bottom, because gases separate: carbon monoxide mixes with air, hydrogen sulfide and many solvent vapours are heavier and collect low, and methane rises. Results go on the permit. During the work the monitor stays with the entrants or the attendant and alarms if conditions change, and the space is retested after any break.

Testing is not a formality. Steel boilers that have been closed and wet for a long time can contain low-oxygen air, even after draining. A space can become hazardous during work too: welding and cutting consume oxygen and make fumes, solvents release vapour, and a leaking valve can let in steam, gas or nitrogen. If an alarm sounds, everyone leaves immediately, and nobody re-enters until the cause is found and the permit is reissued.

Closing up and returning to service

When work is done, the entry supervisor makes sure every person and every tool is out, the inside is clean and clear of rags, lights and loose parts, and the inspector, if one is involved, has finished. A head count matches the attendant's log. Covers go back on with new gaskets, tightened to the maker's instructions. The permit is closed and filed. Isolations are removed in a planned order, the boiler is filled slowly with treated water, vented, checked for leaks and brought up to temperature gradually. Lorne made Tamar count the tools out of boiler 3 against the list the workers had written when they went in, and initial the permit beside his signature.

Confined spaces outside the boiler house

Not every confined space at Cantwell is inside the plant. The steam distribution system runs through tunnels and vaults under the downtown streets, where valves, expansion joints and traps sit in concrete chambers reached through manholes. These spaces can fill with steam from a leaking joint, with water from a broken main, or with gases seeping from the soil or a nearby sewer, and they can be very hot. Every vault entry is treated as a confined space entry with a permit, testing, ventilation and an attendant at the surface, and the work is coordinated with the city when a manhole is in a roadway, because traffic is a hazard of its own.

Hot work in a confined space, such as welding a pipe support inside a vault or cutting out a corroded section of breeching, needs extra precautions: a hot work permit on top of the entry permit, continuous gas monitoring, ventilation that carries the fumes away from the workers, a fire extinguisher at hand, and a stricter flammable gas limit. Grazyna's procedures do not allow any gas cylinder to be taken into a confined space; welding gases are fed in through hoses from cylinders outside, and the hoses are removed whenever work stops.

Rescue planning

A rescue plan is written before the entry, not improvised during an emergency. For boiler drums, Cantwell's plan relies on non-entry rescue: every entrant wears a full body harness attached to a line running to a tripod and winch at the manway, so the attendant can pull them out without going in. Where the shape of the space makes that impossible, such as inside a furnace with baffles or a vault with an offset passage, the plan names a trained rescue team with breathing apparatus who must be on site or able to arrive within a set time before the entry can start. The plan also lists how to call the fire department, the nearest hospital and the plant's first aiders.

Rescue equipment is checked before every entry: the harness inspected, the winch tested with a load, the line checked for wear, and the communication method tested. During the boiler 3 entry Tamar's job was to check off each item on the permit as Pilar inspected it, and to keep the entry log of who went in and came out, and when.

Worked problem

Planning the work time

During the boiler 3 entry, the atmosphere was retested every 30 minutes and after each break. The workers entered at 19:40, took a break from 21:10 to 21:30, and came out for good at 23:20. How many tests were needed, counting the initial test before entry?

Show solution
  1. Before entry:
  2. \[1 \text{ test}\]
  3. First period, 90 minutes of work:
  4. \[90 \div 30 = 3 \text{ tests}\]
  5. After the break:
  6. \[1 \text{ test}\]
  7. Second period, 110 minutes of work:
  8. \[\lfloor 110 \div 30 \rfloor = 3 \text{ tests}\]
  9. Total:
  10. \[1 + 3 + 1 + 3 = 8\]

Answer: Eight tests, each recorded on the permit with the time, the readings and the tester's initials. Continuous monitoring by a gas detector worn by the entrants ran throughout, so the scheduled tests were a check on the monitor as well as on the space.

Common mistakes

  • MistakeEntering to rescue a collapsed worker without breathing protection.

    InsteadRaise the alarm and use the retrieval system from outside; trained rescuers with breathing apparatus go in.

  • MistakeTesting the atmosphere only at the manway.

    InsteadTest at the top, middle and bottom; gases separate.

  • MistakeTrusting a boiler is safe because it has been drained.

    InsteadClosed, wet steel can use up oxygen; always test, and isolate every connection.

  • MistakeUsing 120 V tools and lights inside a drum without protection.

    InsteadUse low-voltage lighting or ground fault protection in wet, conductive spaces.

  • MistakeOpening a manway cover facing the opening.

    InsteadStand to the side, and loosen it only when the boiler is confirmed empty and at zero pressure.

Summary and key terms

  • A confined space is not designed for continuous occupancy and may develop atmospheric hazards; O. Reg. 632/05 applies.
  • Low oxygen, toxic or flammable air, engulfment and unexpected energy are the main dangers; many victims are would-be rescuers.
  • Entry needs a program, an assessment and plan, a permit, testing, an attendant and a rescue plan.
  • Acceptable oxygen is 19.5 to 23 in 100; flammable gas is held below set fractions of the LEL, 10 in 100 for entry in Cantwell's plan.
  • A boiler is cooled, isolated, drained, opened, ventilated and tested before entry.
  • Test at several levels, bump test monitors and retest during the work.
  • Close up with a tool and head count, new gaskets, a closed permit and a slow return to service.
Confined space
An enclosed space not designed for continuous occupancy, where atmospheric hazards may occur.
Entry permit
The written authorization that records the hazards, controls, tests, people and rescue for an entry.
Attendant
The person outside a confined space who monitors, keeps contact and summons rescue.
LEL
Lower explosive limit, the lowest concentration of a gas in air that can burn.
Bump test
A brief exposure of a gas monitor to test gas to prove its sensors respond.
Retrieval system
A harness, line and winch or tripod for pulling an entrant out without entering.

Practice problems

Work each problem on paper first, then reveal the answer to check.

  1. Name three kinds of confined space in a boiler plant.

    Show answer

    A boiler drum, a deaerator, a condensate or chemical tank (also flues, pits and valve chambers).

  2. Why do so many confined space deaths involve rescuers?

    Show answer

    They enter without breathing protection to help and are overcome by the same atmosphere.

  3. Why is the atmosphere tested at several levels?

    Show answer

    Gases separate; some collect low and some rise.

  4. What is the attendant's role if an entrant collapses?

    Show answer

    Raise the alarm and use the retrieval system from outside; never enter.

  5. Why is low-voltage or ground fault protected lighting used inside a drum?

    Show answer

    The space is wet and conductive, so a fault at normal voltage could be fatal.

Lesson quiz · 5 questions

Score 60% or more to complete this lesson.

Take the quiz