GAS-340 · Lesson 9 of 12 · 22 min
Red-tagging and unsafe conditions
▶ Video coming soon A video version of this lesson is on the way.
On Tuesday, February 10, 2026, Rosa was sent to a rented semi-detached house on Oak Street to look at a furnace that was "making a rumbling noise". The furnace's noise was a loose blower wheel, a half-hour repair. But in the same basement she found two other things. The water heater's vent connector had come apart at the chimney, and the water heater was spilling flue gas into the basement each time it fired. And the gas line to the dryer had been extended by someone with a length of rubber hose and two hose clamps. Rosa now had three problems with three different answers. The furnace she could fix. The water heater was an immediate hazard. The dryer connection was a serious code violation, and she had to decide which kind of hazard it was.
This lesson covers what the law and good practice require when a technician finds an unsafe condition on a service call: how conditions are classified, the duty to shut off, tag and notify, how tags are removed, and how to handle the customer when the news is bad. In Ohio there is no single statewide rule for contractors equivalent to a red-tag regulation; the duties come from the codes, the utility's rules, the city's authority and the contractor's own procedures. GAS-110 introduced the ideas; here they are applied in detail.
Unacceptable conditions and immediate hazards
The words used in Ohio vary with the utility and the contractor, but the idea is the same everywhere: some unsafe conditions are immediately hazardous, meaning they could cause injury or damage now, such as a gas leak, flue gas spilling into a living space, a failed or bypassed safety control or a cracked heat exchanger letting flue gas into the air stream, and others are not immediately hazardous but must still be corrected, such as a missing sediment trap or a clearance problem that is not yet causing harm. Bayline's procedure uses the same two levels, as many utilities and contractors do, because they are clear and defensible.
| Condition | Typical classification | Why |
|---|---|---|
| Gas leak at a joint or connector | Immediate hazard | Fire and explosion risk now |
| Flue gas spilling into an occupied space | Immediate hazard | Carbon monoxide now |
| Safety control bypassed or jumpered | Immediate hazard | Protection is gone |
| Heat exchanger breach with flue gas in the air stream | Immediate hazard | Carbon monoxide in the building |
| Unapproved hose or connector material on a gas line | Usually immediate hazard | Can fail or leak without warning |
| Missing sediment trap or test tap | Not immediate | Must be corrected; no hazard now |
| Clearance to combustibles slightly short, no heat damage | Not immediate, judged on site | Fire risk over time |
| Appliance without a nearby manual shutoff valve | Not immediate | Must be corrected |
The classification is a judgment, and it belongs to the technician on site. The same missing clearance that is a long-term concern on one appliance may be scorching the wood on another. When in doubt, the technician treats a condition as the more serious kind, because the cost of being wrong in the other direction can be a life.
The duties for an immediate hazard
When a Bayline technician in Ohio finds an immediately hazardous condition, the company's procedure requires them to shut off the gas to the appliance or the work immediately, attach a red tag stating why, give the customer written notice that the appliance must not be used until the condition is corrected, and call Columbia Gas whenever the hazard involves the utility's equipment, a leak that cannot be isolated at an appliance valve, or a customer who will not allow the gas to be shut off. Columbia Gas can disconnect service when supplying gas creates a safety hazard, and it will not restore service until the hazardous condition has been corrected. The City of Columbus's building officials also have authority under the building code to order an unsafe installation disconnected.
Two things apply in every case. First, if anyone has been injured, poisoned, or there has been a fire or explosion, the occurrence is reported at once: in Ohio, the fire service and Columbia Gas are called, and the scene is left as it is for their investigation except for what safety requires. Second, the technician never leaves an immediately hazardous appliance running because the customer objects. If the customer refuses to allow the shutoff, the technician leaves the building if necessary and calls Columbia Gas, who has the authority to shut off the supply.
The duties when there is no immediate hazard
For a condition that is not immediately hazardous, the gas stays on. Bayline's technician attaches a tag explaining the condition, gives the customer written notice of what must be corrected and why, records it on the work order, and the office follows up within 7 days to offer the repair or confirm that someone else has done it. If the customer will not correct it and the technician believes it could become hazardous, the office informs Columbia Gas. The details of what the utility does with that information are set by its own procedures and tariff.
Worked problem
When are the notices due?
Rosa found the dryer's rubber hose on Tuesday, February 10, 2026. Suppose she had judged it not immediately hazardous. Under Bayline's procedure, by what date must the office follow up with the customer?
Show solution
- Follow-up is due within 7 days of the call:
- \[\text{Feb } 10 + 7 \text{ days} = \text{Tue Feb } 17\]
Answer: The office must follow up by Tuesday, February 17.
What Rosa did at the semi
The water heater was simple to classify. Rosa's analyzer read 280 ppm CO at the draft hood and her monitor 14 ppm in the basement with the water heater firing; the connector had pulled out of the chimney thimble. She shut off the water heater's gas valve, tagged it, and wrote the tenant a notice on the spot and recorded it on the work order, and, because the tenants would have no hot water, called the landlord at once. The dryer was harder. A rubber hose on a gas line is not an approved connector; it can crack, be cut or slip off. It was not leaking when she tested it with solution, but it was lying on the floor where a laundry basket could crush it. She judged it an immediate hazard too, closed the dryer's valve, tagged it and wrote it up in the same notice.
Then she called the landlord. He was unhappy, because the tenants had no hot water and no dryer and he would have to pay for both repairs. Rosa explained each problem plainly, sent him photographs, and offered to do both repairs that afternoon: reconnecting the water heater's vent with a new connector, properly supported and fastened, and replacing the rubber hose with a certified appliance connector and a proper shutoff valve. He agreed. Once both were done and tested, with the water heater passing a spillage test, Rosa removed her tags, recorded the corrections on the work order and gave the landlord a copy. The furnace's blower wheel took the last half hour.
Removing a tag
In Ohio, a tag is removed only by a qualified person after the condition is corrected; Bayline's procedure requires the technician who clears it to record what was done and keep the tag with the work order. Where Columbia Gas has shut off service because of a hazard, it restores service only after the hazard is corrected, and the utility's own technician usually checks before turning the gas back on. A technician who finds a tag left by someone else reads it, corrects the condition if that is the work, and does not relight an appliance just because the customer asks.
The customer conversation
Shutting off someone's heat in February is never easy. The conversation goes best when the technician is calm, specific and helpful. They explain what they found in plain words and show it if they can, explain what the law and their certificate require them to do, and make it clear that the decision is about safety, not sales. They give the options: the repair, a quote, the right to get another contractor. They offer what help they can, a portable heater, a time for the repair. And they write it all down, including what the customer said. A customer who later claims they were not told is answered by the written notice they signed or were given.
Writing the notice
The written notice of an unsafe condition is a legal document, and it is written with care. It names the customer and the address, the appliance by make, model and serial number, the date and time, and the technician and their company and ID. It describes the condition in plain words that the customer can understand and a utility or inspector can act on: not "venting problem" but "vent connector separated from the chimney; flue gas spilling into the basement each time the water heater fires". It says what was done, such as "gas shut off at the appliance valve and tag attached", what the customer must not do, and what must happen before the appliance can be used again. The customer signs it if they will, or the technician notes that it was handed over or left at the premises, and the customer keeps a copy.
A good notice also helps the customer act. It says what kind of contractor can correct the condition, offers the company's own repair if appropriate, and gives a phone number. It avoids language that sounds like a sales pitch, because a notice that reads like an advertisement invites the suspicion that the hazard was invented to sell a furnace. The facts, the readings and the photographs are the notice's authority.
| A written notice includes | Example |
|---|---|
| Customer, address, date and time | Oak Street, Feb 10, 2026, 10:40 |
| Appliance and its identification | Water heater, make, model, serial |
| The condition in plain words | Vent connector separated at the chimney; flue gas spilling |
| What was done | Gas shut off at the appliance valve; tag attached |
| What the customer must not do | Do not use or relight the water heater |
| What must happen next | Reconnect the vent; spillage test before use |
| Technician and signature | Name and ID; customer signature or note |
Tags left by others
Technicians often arrive to find a tag already on an appliance, left by the utility, another contractor or a previous Bayline visit. The tag is read before anything else. It says what was found, when and by whom, and often what must be done. If the call is to correct that condition, the technician corrects it, tests the appliance, and clears the tag as the rules require. If the call is about something else, the appliance stays off: a customer who asks the technician to "just get it going" is told why that cannot happen, and offered the repair. A technician who relights a tagged appliance without correcting the condition takes on the responsibility for whatever happens next, and may be committing an offense.
When the customer is not the owner
Many unsafe conditions are found in rented homes, offices and shops, where the person at the door is not the person who owns the equipment. The duties to shut off and tag do not change. The written notice goes to the occupant, who is the user and has to know not to use the appliance, and the technician makes a reasonable effort to reach the owner or landlord the same day, by phone or through the property manager, and records who was told and when. Tenants often worry about the cost and about who will pay; the technician explains that the repair is usually the owner's responsibility and gives them the written notice to pass on. Where an owner cannot be reached and an occupant has no heat in cold weather, Bayline lends heaters and keeps trying, and the office follows up the next morning.
Common mistakes
MistakeLeaving an immediately hazardous appliance on because the customer objects.
InsteadShut it off; if they refuse, leave and call Columbia Gas.
MistakeClassifying a doubtful condition as the less serious kind.
InsteadWhen in doubt, treat it as an immediate hazard.
MistakeTelling the customer verbally and not in writing.
InsteadGive written notice every time, and keep a copy.
MistakeRemoving a tag before the condition is corrected.
InsteadCorrect it first, then clear the tag as the rules require.
MistakeForgetting the distributor.
InsteadCall Columbia Gas whenever the procedure requires it.
MistakeDisturbing the scene after a CO poisoning or fire.
InsteadMake it safe and leave it for the investigators.
MistakeFixing the job you were called for and ignoring the rest.
InsteadReport every unsafe condition you find, whatever the call was about.
Summary and key terms
- In Ohio, unsafe conditions are treated in two levels, immediately hazardous or not, under the codes, the utility's rules, the city's authority and Bayline's procedure.
- For an immediate hazard the technician shuts off the gas, red-tags the appliance, gives written notice and calls Columbia Gas when the utility's equipment is involved, the leak cannot be isolated or the customer refuses; Columbia Gas may disconnect a hazardous supply and will not restore it until the hazard is corrected.
- For a non-immediate condition the gas stays on, the appliance is tagged, the customer is told in writing and the office follows up within 7 days.
- Injuries, CO poisoning, fire or explosion bring in 911 and Columbia Gas, and the scene is left for them.
- Tags are removed only by a qualified person after correction, and customers get plain explanations, options and written notice.
- Immediately hazardous condition
- An unsafe condition that could cause injury or damage now, requiring the gas to be shut off.
- Non-immediate condition
- An unsafe condition that must be corrected but is not causing harm now.
- Red tag
- The common name for the notice attached to an appliance found unsafe.
- Utility disconnect
- The utility's shutoff of a supply because it creates a safety hazard.
- Written notice
- The signed or delivered statement that tells the customer what was found and what they must not do.
- Approved appliance connector
- A connector certified for gas appliance connections, unlike a rubber hose.
Practice problems
Work each problem on paper first, then reveal the answer to check.
Who decides whether an unsafe condition is an immediate hazard?
Show answer
The technician who finds it, judging what they see.
What does Bayline's procedure require for an immediate hazard in Ohio?
Show answer
Shut off the gas, red-tag the appliance, give written notice, and call Columbia Gas when the utility's equipment is involved, the leak cannot be isolated or the customer refuses.
What does Columbia Gas do once it has disconnected a hazardous supply?
Show answer
It does not restore service until the hazardous condition has been corrected.
Why did Rosa treat the dryer's rubber hose as an immediate hazard although it was not leaking?
Show answer
It was not an approved connector and could be crushed, cut or slip off without warning.
What should a technician do if a customer refuses to allow a hazardous appliance to be shut off?
Show answer
Leave if necessary and call Columbia Gas, who can shut off the supply.
Lesson quiz · 5 questions
Score 60% or more to complete this lesson.
Create a free account to save your progress, take quizzes and earn a certificate.